CONFIGURATION (Page Two of Two)





Set Font Size:  ImprocRAD adjusts the size of its controls to the size, in pixels,

of the system's display screen.  The adjustment of the main window buttons and

of dialog boxes is determined by the font size.  Its value can be automatically

calculated to fit the boxes to the screen size, or the font size can be manually

set.   Enters the number in the corresponding edit control as the type font size

used in constructing dialog boxes and thereby the sizes of the dialog boxes

themselves. The default value is 16 point. The button bar size is changed

immediately on pressing the font size button. The used is not protected from

choosing fonts that are too large or too small.  A font that is too large will

cause some of the Button Bar to disappear from the screen.  A font that is too

small will be unreadable.



Hog Palette:  This control is available for the case that the system is running

in 256-color paletted mode and you wish to run two or more instances of ImprocRAD

simulateously.  Because ImprocRAD will normally relinquish control of the palette

back to system colors when applications are switched, the ImprocRAD palette is

exited even when moving to another version of ImprocRAD.  Therefore the 'Hog

Palette' radio button should be selected when running multiple ImprocRAD copies.



Load Default:  reads the default configuration values from the 

file ConfigDefault.txt and resets the internal configuration to those values. 



Save Configuration:  writes the present internal configuration values to the 

file Configuration.txt.  Both the current and the default configuration files are in 

the DOS ASCII format and can be edited using the MS-Windows Notepad.



(Crash Recovery for 256 Color Mode:  Upon exiting ImprocRAD normally, the windows

display appearance is restored to a scheme that is maintained internally to

ImprocRAD.)



Save Colors:  This button is useful only for paletted modes. Pressing this button

saves the color scheme that was in use at the time ImprocRAD was started. If you

wish to change the stored color scheme, before starting ImprocRAD select the color

scheme you wish from the display button in the control panel.  On entering ImprocRAD,

press the Save Colors button in the configuration dialog box. 



Restore Colors:  If you should wish to refresh the internally stored system color

scheme, press restore colors.  The appearance when ImprocRAD is used for the first

time corresponds the the Windows 'Desert' color scheme





This help file was updated on June 13, 2000.